Wireless-N ADSL2+ Modem Router DGN2000 Reference Manual
Configuring Your Wireless Network and Security Settings 2-19
v1.0, July 2008
:
• Entering a PIN. If you want to use the PIN method, select the PIN radio box. A screen
similar to the one shown below displays.
– Go to your wireless client and, from the client’s WPS utility, obtain the wireless
client’s security PIN, or follow the client’s WPS utility instructions to generate a
security PIN.
– Then, enter this PIN in the Enter Client’s PIN field provided on the modem router
and click Apply. You have 4 minutes to enable WPS on the router using this method.
Using either method, the client wireless device will attempt to detect the WPS signal from the
modem router and establish a wireless connection in the time allotted.
• While the modem router attempts to connect to a WPS-capable device, the Push 'N'
Connect LED on the front of the modem router blinks green. When the modem router has
established a WPS connection, the LED is solid green.
Figure 2-6
Figure 2-7
To Next Page
Loading...
Need help?
General
