NETGEAR M4100 Series Software Setup Manual

Get Started
15
M4100 Series Switches
8. Select the Configuration Method Manual radio button.
9. In the IP Address field, enter the network IP address for the switch.
For example, enter 10.100.4.100.
10. In the Subnet Mask field, enter the network subnet mask for the switch.
For example, enter 255.255.255.0.
11. Click the Apply button.
Your settings are saved.
12. Log out of the web management interface.
13. Return your computer to its original settings.
If you want to log in to the web management interface again, you now must use the newly
assigned network IP address.
Access the Web Management Interface When the Switch Is
Already Connected to the Network
This procedure describes how to access the web management interface when you already
configured the management VLAN IP address of the switch.
 To access the web management interface:
1. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port
on the switch.
2. Launch a web browser such as Google Chrome, Mozilla Firefox, or Microsoft Internet
Explorer
.
3. Enter the management VLAN IP address of the switch in the web browser address field.
The Login screen displays.
4. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
5. Click the Login button.

NETGEAR M4100 Series Specifications

General

Model	M4100 Series
Switch Type	Managed
Form Factor	Rack-mountable
Port Configuration	24 or 48 ports
Ethernet Ports	10/100/1000 Mbps
PoE Support	Available on some models (PoE and PoE+)
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Stackable	Yes
Ports	24 or 48
Jumbo Frame Support	Yes
Security Features	ACL, 802.1X, RADIUS, TACACS+
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Power Supply	Internal power supply