NETGEAR M4100 Series Software Setup Manual

17
2
2. Use the Auto Install Configuration
Auto Install is a software feature that provides for the configuration of a switch automatically
when the switch is initialized and no configuration file is found on the switch.
This chapter includes the following sections:
• Auto Install Configuration Concepts
• Switch IP Address Assignment Concepts
• TFTP IP Address and Configuration File Name Concepts
• About Conflicting TFTP Server Configurations
• About DNS Server Requirements
• About Obtaining a Configuration File
• Configure Auto Install

NETGEAR M4100 Series Specifications

General

Model	M4100 Series
Switch Type	Managed
Form Factor	Rack-mountable
Port Configuration	24 or 48 ports
Ethernet Ports	10/100/1000 Mbps
PoE Support	Available on some models (PoE and PoE+)
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Stackable	Yes
Ports	24 or 48
Jumbo Frame Support	Yes
Security Features	ACL, 802.1X, RADIUS, TACACS+
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Power Supply	Internal power supply