NETGEAR M4100 Series Software Setup Manual

Get Started
17
M4100 Series Switches
10. If you do not need authentication and encryption, go to Step 14.
11. To enable authentication, from the Authentication Protocol menu, select either MD5 or
SHA.
12. If you do not need encryption, go to Step 14.
13. To enable encryption, do the following:
a. From the Encryption Protocol menu, select DES.
b. In the Encryption Key field, enter an encryption code of eight or more alphanumeric
characters.
14. Click the Apply button.
Your settings are saved.

NETGEAR M4100 Series Specifications

General

Model	M4100 Series
Switch Type	Managed
Form Factor	Rack-mountable
Port Configuration	24 or 48 ports
Ethernet Ports	10/100/1000 Mbps
PoE Support	Available on some models (PoE and PoE+)
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Stackable	Yes
Ports	24 or 48
Jumbo Frame Support	Yes
Security Features	ACL, 802.1X, RADIUS, TACACS+
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Power Supply	Internal power supply