NETGEAR R6250

ReadySHARE Printer
60
R6250 Smart WiFi Router
Control Center Configuration
 To use the Control Center Configuration screen:
1. Select T
ools > Configuration.
2. Specify the following settings:
• Automatically execute when logging on W
indows. Enable this utility to start
automatically when you are logged in to Windows.
• T
imeout. Specify the time-out value for holding the USB resource when it is not in
use.
• Language. Select the display language for this utility
.
3. Click OK.
Your changes are saved.
USB Printer
The first time you use a printer, click Connect. You might be asked to install the driver for this
printer. After the driver is installed, the printer status changes to Available.
Note: Some USB printers (for example, HP and Lexmark printers) request
that you do not connect the USB cable until you are prompted to do
so by the printer driver installation software.
If the USB printer is detected and connected automatically, you need to disconnect the printer
and wait for the prompt asking you to click Connect.