Table 1. LED descriptions (Continued)
DescriptionLED
Pressing this button for two seconds turns the 2.4 GHz, 5 GHz, and 60 GHz WiFi radios on and
off.
If this LED is lit, the WiFi radios are on. If this LED is off, the WiFi radios are turned off and you
cannot use WiFi to connect to the router.
WiFi On/Off button with LED
This button lets you use WPS to join the WiFi network without typing the WiFi password.The
WPS LED blinks white during this process and then lights solid white.
WPS button with LED
If the LED On/Off switch is moved to the Off position, all the LEDs except the Power
LED are turned off.
Note
Rear Panel
The rear panel connections and buttons are shown in the following figure.
Figure 3. Rear panel
Viewed from left to right, the back panel contains the following components:
• LED On/Off switch. If this switch is in the Off position, all the router’s LEDs, including the LEDs on the
four active antennas, but not the Power LED, are turned off.
• Reset button. Pressing the Reset button resets the router. If the Reset button is pressed for at least
seven seconds and the Power LED blinks white, the router returns to its factory settings. For information
about the factory settings, see Factory Settings on page 155.
• Ethernet ports. Six Gigabit Ethernet RJ-45 LAN ports to connect the router to LAN devices. Ethernet
port aggregation is enabled by default. Use Ethernet aggregate ports 1 and 2 to cable a device that
supports Ethernet port aggregation to the router. Ethernet ports 3, 4, 5, and 6 are nonaggregate Ethernet
ports.
• Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the router to a cable modem.
• 10G LAN SFP+ port. One 10G LAN SFP+ port to connect an SFP+ module.
Hardware Setup
12
Nighthawk X10 AD7200 Smart WiFi Router
To Next Page
Loading...
Need help?
General
