Supplemental Information
105
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Factory Default Settings
You can use the Reset button located on the rear of the wireless access point to reset all
settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset button for
approximately five seconds (until the Test LED blinks rapidly). This returns the wireless
access point to the factory configuration settings that are shown in the following table.
Note: Pressing the Reset button for a shorter period of time simply causes
the wireless access point to reboot.
Status LEDs • Power/Test LED
• Activity LED
• Ethernet LAN
• Wireless LAN (2.4 GHz and 5 GHz)
Electrical and Physical Specifications
Power adapter 12 VDC, 2.5A; plug is localized to country of sale
Physical specifications • Dimensions (h x w x d): 197.3 x 197.3 x 40 mm (7.76 x 7.76 x 1.57 in.)
• Weight: 762 g (1.6 lb)
Environmental
specifications
Operating temperature: 0 to 40°C (32 to 131°F)
Operating humidity: 10–90%, noncondensing
Electromagnetic
compliance
• FCC Part 15 SubPart B
• FCC Part 15 SubPart C
• FCC Part 15 SubPart E
• CE
• C-TICK
Table 5. Default configuration settings
Feature Description
Login for management and configuration
LAN IPv4 management address 192.168.0.100
Subnet mask for IPv4 management address 255.255.255.0
LAN IPv6 management address 2001::21c:c0ff:fe69
Table 4. Technical specifications (continued)
Feature Description
To Next Page
Loading...
