NETGEAR WAC720

Management and Monitoring
55
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Restore the Configuration
 To restore your settings from a saved configuration file:
1. Select Maintenance > Upgrade > Restore Settings.
2. Click the Browse button and locate the backup configuration file (the file name is config).
IMPORTANT:
During the restoration process, do not try to go online, turn off the
wireless access point, shut down the computer, or do anything else
to the wireless access point until it finishes restarting!
3. Click the Apply button to initiate the restoration process.
During the restoration process, the wireless access point automatically restarts. The
restoration process typically takes about one minute. When the Test LED turns off, wait a
few more seconds before doing anything with the wireless access point.
Restore the Wireless Access Point to the Factory Default
Settings
You can restore the wireless access point to the factory default settings by two methods that
are described in the following sections:
• Use the Web Management Interface to Restore Factory Default Settings
• Use the Reset Button to Restore Factory Default Settings
Note: After you restore the factory default settings on the wireless access
point, the following occurs:
* All custom configurations are lost.
* The login password is password.
* The default LAN IP address is 192.168.0.100.
* The DHCP client is disabled.
* The Access Point Name field is reset to the name printed on
the label on the bottom of the unit.