NETGEAR WAC720

Advanced Configuration
91
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
3. Click the Apply button.
Your settings are saved.
4. Select Configuration > Security > Profile Settings.
The Profile Settings page displays.
5. Select the radio button the left of the wireless security profile (SSID) with which you want to
associate a captive portal.
6. Click the Edit button.
The Edit Security Profile page displays.
7. From the menu in the Captive Portal section, select the profile name of the captive portal
that you want to associate with the SSID.
8. Click the Apply button.
The captive portal is enabled on the SSID.
Configure Wireless Bridging
The wireless access point supports a wireless distributing system (WDS) that lets you build
large bridged wireless networks.
Point-to-Point Bridge and Point-to-Multipoint Bridge
You can set up a single point-to-point bridge or create a point-to-multipoint bridge by setting
up to four point-to-point bridges with your wireless access point functioning as the master:
• Wireless point-to-point bridge. The wireless access point communicates with another
bridge-mode wireless access point and with wireless clients. You can use WPA2-PSK to
secure the communication. The following figure shows an example in which two wireless
access points (APs) function in point-to-point bridge mode.
Figure 6. Point-to-point wireless network
WiFi client
WiFi client
Internet
AP1 in
point-to-point
bridge mode
AP2 in
point-to-point
bridge mode
LAN segment 1
LAN segment 2