NETGEAR WAC720

Initial Setup
25
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
After you complete the configuration of the wireless access point, you can reconfigure the
computer that you used for this process back to its original TCP/IP settings.
Mount the Wireless Access Point
The following sections explain how to mount your wireless access point. We recommend that
you review the information in Wireless Equipment Placement and Range Guidelines on
page 11 before you mount the wireless access point at its permanent position.
• Package Content of the Ceiling and Wall Installation Kit
• Drop Ceiling Installation
• Wall Installation
Package Content of the Ceiling and Wall Installation Kit
Figure 4. Ceiling and wall installation kit
The ceiling and wall installation kit contains the following components:
• One access point mounting bracket (1)
• One wall mounting bracket (2)
• Six mounting screws with integrated washers for the access point mounting bracket (3)
• One T-bar screw for the access point mounting bracket (4)
• Four wall screws for the wall mounting bracket (5)
• Four wall anchors for the wall mounting bracket (6)
Drop Ceiling Installation
The best location for ceiling installation is at the center of your wireless coverage area, and
within line of sight of all mobile devices. Make sure that the top (the dome side) of the
wireless access point is directed toward the users and not the ceiling.
1
2
3
5
6
4