NETGEAR WAC720

Management and Monitoring
62
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
View System Information
You can view a summary of the current wireless access point configuration settings,
including current IP settings and current wireless settings. This information is read only, so
any changes must be made on other pages.
 To view the System page:
Select Monitoring > System.
The following table explains the fields of the System page:
Setting Description
Access Point Information
Access Point Name The NetBIOS name. For information about how to change the default name, see
Configure Basic General System Settings and Time Settings on page 16.
Ethernet MAC Address The MAC address of the wireless access point’s Ethernet port.
Wireless MAC Address
for 2.4 GHz
The MAC address of the wireless access point’s wireless card when operating at
2.4 GHz.
Wireless MAC Address
for 5 GHz
The MAC address of the wireless access point’s wireless card when operating at
5 GHz.
Ethernet LLDP Enabled indicates that LLDP is enabled. Disabled indicates that it is not.