NETGEAR WAC720

Advanced Configuration
87
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
5. (Optional) Specify rate limiting for the classification as explained in the following table:
6. Click the Add button.
The classification is added to the Classifications field.
7. To add another classification to the QoS policy, repeat Step 4, Step 5, and Step 6.
8. Click the Apply button.
The QoS policy is saved.
Match Frame
Fields and Match
Classifications
(continued)
Source IP In the Match Classifications field, enter the source IP address against
which the information in the IP header must be matched.
Destination IP In the Match Classifications field, enter the destination IP address
against which the information in the IP header must be matched.
Source Port The Match Classifications field is separated into two sections. In the
left section, enter the source port number, and optionally, in the right
section, enter the associated IP address against which the information
in the IP header must be matched.
Destination
Port
The Match Classifications field is separated into two sections. In the
left section, enter the destination port number, and optionally, in the
right section, enter the associated IP address against which the
information in the IP header must be matched.
Apply
Classification
From the Apply Classification menu, select the traffic class that must be applied to the
packets that match the selection in the Match Classifications field:
• Best Effort(0)
• Background(1)
• Spare(2)
• Excellent(3)
• Control Load(4)
• Video < 100 ms Latency(5)
• Voice < 10 ms Latency(6)
• Network Control(7)
Setting Description
Classification
Rate Limiting
Basic Rate Enter a value between 1 and 1,000,000 Kbytes/sec to specify the
maximum data rate up to which packets that match the classification
are queued for transmission and sent immediately over the wireless
interface. This value applies only to traffic that matches the
classification.
Note: When the maximum rate is exceeded, packets are retained in
the queue and sent when the transmission falls again below the
maximum rate.
Burst Rate Enter a value between 1 and 204,800,000 bytes to specify the
maximum amount of data that can be transmitted in a burst for packets
that match the classification. This value applies only to traffic that
matches the classification.
Setting Description