Monitoring
40
ProSafe Wireless-N Access Point WNAP210
System Information
The System screen you access from the Monitoring tab provides a summary of the current
access point configuration settings, including current IP settings and current wireless
settings. This information is read-only, so any changes have to be made on other screens.
To access the System screen, select Monitoring > System.
This screen shows the following information:
• Access Point Name. The NetBIOS name. The default name can be changed.
• MAC Address. The MAC address of the access point’s Ethernet port.
• Country/Region. The domain or region for which the access point is licensed for use. It
might not be legal to operate this access point in a region other than one of those
identified in this field.
• Firmware Version. The version of the firmware currently installed.
• Current Time. The time setting for the access point.
• IP Address. The IP address of the access point.
• Subnet Mask. The subnet mask for the access point.
• Default Gateway. The default gateway for the access point communication.
• DHCP Client. Enabled indicates that the current IP address was obtained from a DHCP
server on your network. Disabled indicated a static IP configuration.
• Access Point Mode. The operating mode of the access point: Access Point or
Point-to-point • Channel/Frequency. The channel the wireless port is using.
• Rogue AP Detection. Shows whether the rogue AP detection feature is enabled.
To Next Page
Loading...
Need help?
General
