EasyManuals Logo

NETGEAR WNAP210 User Manual

NETGEAR WNAP210
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
Supplemental Information
63
ProSafe Wireless-N Access Point WNAP210
Factory Default Settings
You can use the Restore Factory Settings button on the rear panel to reset all settings to their
factory defaults. This is called a hard reset. Pressing this button for a shorter period of time
simply causes your device to reboot.
Restore
Factory
Settings
To perform a hard reset:
1. Use something with a small point, such as a pen, to press the Restore Factory Settings
button in and hold it in for at least 5 seconds (until the Test LED blinks rapidly).
2. Release the button.
Your device returns to the factory configuration settings shown in the following table.
Table 5. Access point default configuration settings
Feature Default setting
Login URL 192.168.0.236
User name (case-sensitive) admin
Login password (case-sensitive) password
Static IP address 192.168.0.210
Ethernet MAC address See bottom label.
Port speed 10/100/1000
LAN IP 192.168.0.236
Subnet mask 255.255.255.0
Gateway address 0.0.0.0
DHCP client Disabled
Time zone USA-Pacific
Time zone adjusted for daylight saving
time
Disabled
SNMP Enabled, but trap forwarding disabled

Table of Contents

Other manuals for NETGEAR WNAP210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WNAP210 and is the answer not in the manual?

NETGEAR WNAP210 Specifications

General IconGeneral
BrandNETGEAR
ModelWNAP210
CategoryWireless Access Point
LanguageEnglish

Related product manuals