EasyManuals Logo

NETGEAR WNAP210 User Manual

NETGEAR WNAP210
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
Advanced Configuration
57
ProSafe Wireless-N Access Point WNAP210
A computer on any LAN segment should be able to connect to the Internet or share files
and printers with computers or servers connected to any of the three WLAN segments.
8. Click Apply to save your settings.
You can extend repeating by adding up to two additional access points configured in repeater
mode. However, since repeater configurations communicate in half-duplex mode, the
bandwidth decreases as you add repeaters to the network.
Client Mode
In client mode the access point operates as a client bridge only and sends traffic to the
selected remote AP or peer device.
To configure the access point for client mode:
1. Select Configuration > Wireless Bridge > Bridging and Repeating. The Bridging and
Repeating screen displays.
2. Select the Enable Wireless Bridging and Repeating check box. This allows you to select
a bridging mode.
3. Select Client. You can now enable the MAC clone feature. The default is Disable. If you
enable the MAC clone feature, enter the MAC clone address.
4. Click Apply.

Table of Contents

Other manuals for NETGEAR WNAP210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WNAP210 and is the answer not in the manual?

NETGEAR WNAP210 Specifications

General IconGeneral
BrandNETGEAR
ModelWNAP210
CategoryWireless Access Point
LanguageEnglish

Related product manuals