Advanced Configuration
51
ProSafe Wireless-N Access Point WNAP210
The following table describes the settings for QoS queues.
Table 4. QoS queues and parameters
QoS queue Description
Data 0 (Voice) High-priority queue, minimum delay. Time-sensitive data such as VoIP and
streaming media are automatically sent to this queue.
Data 1 (Video) High-priority queue, minimum delay. Time-sensitive video data is
automatically sent to this queue.
Data 2 (Best Effort) Medium-priority queue, medium throughput and delay. Most traditional IP
data is sent to this queue.
Data 3 (Background) Lowest-priority queue, high throughput. Bulk data that requires maximum
throughput and is not time-sensitive is sent to this queue (FTP data, for
example).
AIFS
(Arbitration Inter-Frame Space)
Specifies a wait time (in milliseconds) for data frames. Valid values for AIFS
are 1 through 255.
cwMin
(Minimum Contention Window)
Upper limit (in milliseconds) of a range from which the initial random backoff
wait time is determined. Valid values for the cwMin are 1, 3, 7, 15, 31, 63,
127, 255, 511, and 1024. The value for cwMin has to be lower than the
value for cwMax.
cwMax
(Maximum Contention Window)
Upper limit (in milliseconds) for the doubling of the random backoff value.
Valid values for the cwMax are 1, 3, 7, 15, 31, 63, 127, 255, 511, and 1024.
The value for cwMax has to be higher than the value for cwMin.
Max. Burst Length Specifies (in milliseconds) the maximum burst length allowed for packet
bursts on the wireless network. A packet burst is a collection of multiple
frames transmitted without header information. Valid values for maximum
burst length are 0.0 through 999.9.
Wireless Bridging and Repeating
The access point lets you build large bridged wireless networks. Select Configuration >
Wireless Bridge.
To Next Page
Loading...
Need help?
General
