EasyManuals Logo

NETGEAR WNAP210 User Manual

NETGEAR WNAP210
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Management
34
ProSafe Wireless-N Access Point WNAP210
Remote Console
1. Select Maintenance > Remote Management > Remote Console.
2. Enter the following information in the Remote Console screen.
Secure Shell (SSH). If set to Enable, the wireless access point allows remote access
only through Secure Shell and Secure Telnet. The default is Enable.
Telnet. If set to Enable, the wireless access point allows remote access through
Telnet. The default is Disable. If Telnet is enabled and the access point is accessed
using a browser, the Telnet access is disconnected.
3. Click Apply.
Management Using Telnet
1. Open a secure Telnet session from your computer to the access point. The screen
shown in the following figure should display.
2. Enter the login name and password (admin and password are the defaults).
After successful login, the <Access Point Name> prompt should display. In this example,
the prompt is netgear334408.
3. Enter the desired CLI commands. You can enter
help to display the CLI command help.
The CLI commands are listed in Appendix B, Command Line Reference.

Table of Contents

Other manuals for NETGEAR WNAP210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WNAP210 and is the answer not in the manual?

NETGEAR WNAP210 Specifications

General IconGeneral
BrandNETGEAR
ModelWNAP210
CategoryWireless Access Point
LanguageEnglish

Related product manuals