LCD Touchscreen Interface 43
Status of connection to mobile broadband network (Connected /
disconnected).
Network type (GSM, 3G, LTE).
The signal strength listed as a number of bars (a higher number means a
stronger signal).
The following values appear if the Network status is LTE.
The signal strength of the network (Reference Signal Received Power).
The signal quality of the network (Reference Signal Received Quality).
Signal to Interference Noise Ratio based on Reference Signals (narrowband
and wideband).
The LTE cell that is currently serving the hotspot.
The LTE Band being used for the connection.
The transmitter power. A higher number is better.
The receiver power. A higher number is better.
The following values appear if the Network status is CDMA / 3G.
Signal strength of the network.
Dimensionless ratio of the average power of a channel, typically the pilot
channel, to the total signal power.
Signal strength of the network.
Dimensionless ratio of the average power of a channel, typically the pilot
channel, to the total signal power.
DRC (Digital Rate control) channel number.
PRL (Preferred Roaming List) version. To update the PRL, see Network >
Preferences Tab.
The following values appear if the Network status is GSM.
Power level in the received radio signal (Received Signal Strength Indication)
Quality of the pilot channel as a ration of the received power to overall noise.
Received Signal Code Power.
To Next Page
Loading...
Need help?
General
