Payment Terminals | Page 41 of 54
12. Operators
The Operator function is used to register and delete operators using the terminal. Operators are registered with
a unique Operator ID (up to 10 digits) and name. Each operator must be registered on each terminal that they
use. It is possible to access-protect operators by activating a four-digit code. The first operator to register with
his/her code becomes the Master. The Master operator is the only person who can create or delete registered
operators.
NB: If your payment terminal is integrated with an ECR, these functions must be called from the ECR and not
directly from the payment terminal.
12.1 Create a New Operator
Use the instructions in this section to register a new operator on the payment terminal.
Swipe the Merchant Card (with the magnetic strip facing left).
Merchant menu
1 Issuers
2 EOT
3 Operator admin
Press 3 or scroll down to Operator Admin.
Operator admin
1 Add Op.
2 Delete Op.
3 Print ops.
Press OK to register a new operator.
Operator Id: Enter operator number, then press OK.
Operator Name:
ABC
Enter operator name. To use lower case letters, use key F4 (top-right of
terminal) to toggle.
Operator PIN:
Enter the optional four-digit PIN, then press OK. If a PIN is not required,
the field may be left empty; then simply press OK.
Operator added
To Next Page
Loading...
