Model H1301 Recovery and Recycling System
Installation, Operation and Maintenance Manual
Revision-L September, 2019
Page 2 of 105
Table of Contents page
I. Unpacking and Inspection 4
Figure #1: High and Low Side Gauges 4
II. System Warnings 5
A. General Safety Issues 5
B. Installation Warnings 5
C. Operation Warnings 6
D. Maintenance Warnings 7
III. General System Description 8
Figure #2: System Component Overview 8
IV. System Installation 9
Figure #3: Dimensional Reference 9
A. Machine Location 10
Figure #4: Port Locations 10
B. Pressure Relief Valve 11
C. Electrical Supply Requirements 12
D. Nitrogen Vent Port 13
E. Nitrogen Supply 14
F. Agent Receiver Storage Container Connections 15
G. Agent Source Container Connections 19
V. System Operation and Controls 22
A. Manual Overrides and System Control Description 22
Figure #5: Front Control Panel Detail 23
B. Initial System Start-Up Procedure 26
C. Inlet Pressure Switch Description and Adjustments 28
D. Automatic System Operation 32
E. Disconnecting the Source Container When it is not Empty 35
F. Receiving Container Replacement 36
G. System Shutdown 37
VI. System Operation Description and Component Review 38
A. PLC Status Indicators 38
B. The Nitrogen Vent Cycle 39
C. Inlet Recovery Review 40
D. Filtration Review 40
E. Nitrogen Separation Review 41
F. Pump Out Review 42
(Table of Contents Continues on Next Page)
To Next Page
Loading...