Model H1301 Recovery and Recycling System
Installation, Operation and Maintenance Manual
Revision-L September, 2019
Page 5 of 105
II. System Warnings
The following lists warnings concerning the installation, operation, and maintenance of the
system as well as general safety issues. The warnings listed here are both specific and
generalized and may or may not be repeated throughout the manual
A. General Safety Issues
KEEP AWAY FROM LIVE ELECTRICAL CIRCUITS. Operating personnel should
observe all safety precautions at all times. Do not replace components or make
adjustments inside the equipment with the high voltage energized to the system unless
directed to do so in the maintenance sections of this manual. Dangerous potentials exist
internal to the system and under certain conditions may exist even with the system power
switch in the off position.
DO NOT SERVICE OR ADJUST THE SYSTEM ALONE. All maintenance or
system adjustments should be accomplished in the presence of someone capable of
rendering aid in the unlikely event of injury.
ONLY PERMIT FULLY TRAINED PERSONEL TO OPERATE THE SYSTEM.
COMPLETELY READ AND UNDERSTAND THIS MANUAL BEFORE
ATTEMPTING INSTALLATION, OPERATION, OR MAINTENANCE TO THE
EQUIPMENT.
ALWAYS WEAR SAFETY GLASSES when operating the equipment or working with
the Agent containers.
B. Installation Warnings
DO NOT INSTALL THE SYSTEM IN AN OUTDOOR ENVIRONMENT. The
system is designed for indoor locations with ambient temperature from 70 to 80 degrees F
(21.1 to 26.7C).
DO NOT LOCATE THE SYSTEM NEAR DRIPPING, SPRAYING, OR
STANDING MOISTURE OR WATER. The system enclosure IS NOT NEMA rated.
Contact with moisture and water may result in electrical short circuits which may cause
health and system hazards.
ALWAYS LOCATE THE SYSTEM ON AN EVEN AND LEVEL SURFACE, use
wheel chocks to insure the machine will not roll if accidentally pushed, or roll from
operational vibration.
ALWAYS MAINTAIN A SERVICE AREA OF 3-FEET AROUND ALL SIDES OF
THE MACHINE to provide adequate ventilation of the refrigeration section.
ALWAYS ATTEMPT TO LOCATE THE SYSTEM IN AN AREA THAT IS
COOL, DRY, AND AWAY FROM DIRECT SUNLIGHT.
DO NOT LOCATE THE EQUIPMENT IN OR NEAR THE VICINITY OF FLAMMABLE
MATERIALS OR VAPORS.
DO NOT CONNECT THE EQUIPMENT TO ANY POWER SOURCE OTHER THAN
SPECIFIED BY THE INSTALLATION PROCEDURES OF THIS MANUAL. FOLLOW
LOCAL AND NATIONAL SAFETY CODES WHEN INSTALLING THE EQUIPMENT.
ALWAYS ATTEMPT TO MAINTAIN A MINIMUM 3/16” INSIDE DIAMETER
PLUMBING CONNECTIONS TO THE PORTS OF THE MACHINE WITH A MINIMUM
OF BENDS, LOOPS, LOW SPOTS, OR SAGS.
To Next Page
Loading...