Model H1301 Recovery and Recycling System
Installation, Operation and Maintenance Manual
Revision-L September, 2019
Page 4 of 105
I. Unpacking and Inspection
A. Upon receipt of the system, visually inspect the shipping carton for signs of
damage or mishandling. Immediately contact the carrier for an inspection if the
shipping carton is damaged or evidence of mishandling exists.
B. Carefully remove the outer crating materials. Care must be taken during
unpacking to avoid enclosure damage or scratching.
C. Inspect the system for dents, scratches, or other evidence of mishandling during
shipment. Request an immediate inspection from the carrier if damage is evident.
D. Inventory the contents of the shipping carton against the packing list provided
with the shipping documents.
E. Observe the pressure indications of the Refrigeration Section: System #1- High
and Low side and System #2 ā High and Low side pressure gauges located at
the lower-rear panel of the machine: refer to figure #1 below. Pressure
indications below 130 psi for system #1 and below 65 psi for system #2 may
indicate a break in the plumbing: Contact the factory for further assistance.
F. Open the Filter Access Door located at the top-right corner of the Control Panel
Black Hood. Using an inspection light source visually verify the integrity of the
internal tubing contained under the Hood. Close the Filter Access Door.
To Next Page
Loading...