Model H1301 Recovery and Recycling System
Installation, Operation and Maintenance Manual
Revision-L September, 2019
Page 6 of 105
II. System Warnings (continued)
C. Operation Warnings
DO NOT OPERATE THE EQUIPMENT WITH THE EXTERNAL PANELS
REMOVED.
DO NOT RESTRICT THE FLOW OF AIR THROUGH THE ENCLOSURE
GRATES.
DO NOT INTRODUCE ANY SUBSTANCE OTHER THAN AGENTS HALON
1301, HALON 1211, FM200, FE25 OR CLEAN DRY NITROGEN GAS INTO THE
EQUIPMENT.
DO NOT INTRODUCE AGENT INTO THE EQUIPMENT THAT IS KNOWN TO
EXCEED THE FOLLOWING CONTAMINATION LEVELS:
Moisture in excess of 100 PPM
Oil in excess of 500 PPM
Acid in excess of 80 PPM
Particulates in excess of 80 PPM
DO NOT INTRODUCE AGENT INTO THE EQUIPMENT THAT IS
CONTAMINATED WITH SUBSTANCES OTHER THAN MOISTURE, OIL,
ACID, PARTICULTES NITROGEN OR AIR. The equipment is only capable of
removing the aforementioned contaminates and WILL NOT purify Agent contaminated
with other substances.
DO NOT EXCEED INPUT PRESSURES GREATER THAN 600 PSIG
PROPERTY DAMAGE AND INJURY MAY RESULT.
NEVER OPERATE THE SYSTEM WITHOUT AN EXTERNAL STORAGE
VESSAL CONNECTED TO THE OUTPUT PORT OF THE SYSTEM. Failure to
connect a storage container to the outlet port of the machine could result in total loss of
recovered Agent.
NEVER OPERATE THE SYSTEM WITHOUT A SOURCE OF AGENT OR
CLEAN DRY NITROGEN CONNECTED TO THE INLET PORT OF THE
SYSTEM. Failure to connect a source container to the inlet port of the machine may
result in the introduction of ambient air into the system that will saturate the moisture
filters and cause ice formation and internal blockage to the machine.
DO NOT RESTRICT THE NITROGEN VENT PORT OF THE MACHINE.
Restricting the vent port may result in poor recycling quality.
ALWAYS SECURE THE SOURCE CONTAINER BEFORE DISCHARGE OF
THE CONTAINER. Source containers such as system tanks may be under extreme
pressures and will present a hazardous condition if not properly handled by trained
personnel.
ALWAYS EVACUATE EMPTY EXTERNAL STORAGE VESSALS AND
ASSOCIATED PLUMBING TO A 2500-MICRON MINIMUM VACUUM LEVEL
BEFORE PROCESSING AGENT THROUGH THE MACHINE.
To Next Page