30
Add Receiver
The MPCW-7 stores any receivers it uses in memory. If a new receiver is required because of a new scoreboard
installation, maintenance, or a new component in the existing Nevco, Inc. scoring system begin by adding a
receiver.
Be sure to have the receiver serial number ready it will be needed to add a receiver to the MPCW-7.
From the “Link Receiver” screen:
1. From the Link Receiver screen: press until the display shows
2. Press the MPCW-7 will display
3. Enter the six digit receiver serial number
a. The control will then navigate to name the receiver
4. Enter a receiver name using the team name number and letter keys.
a. The receiver name is entered just as a team name is. For more reference refer to
the “Team Names” Section
b. It is recommended to name the receiver according to what it controls
Note: Once a new receiver is added it is added to all profiles as linked. If this is not a desirable state
then for each profile used save it according to what the receiver needs are.
Link Receiver
The MPCW-7 allows the user to choose which wireless receivers to use during operation. The receivers used
default to being linked this setting allows one to toggle the use of each receiver added to the MPCW-7. To link
or unlink a receiver:
1. If using profiles load the profile desired to change the wireless settings
a. Refer to the Profiles section of this manual
2. Enter the wireless options menu by pressing OPTIONS until “Wireless” displays and
pressing YES. MPCW-7 will display the Link Receiver screen.
3. Press the MPCW-7 will display the first receiver added to the MPCW-7
4. If that receiver is desired to link or be unlinked press
a. The asterisk designates a Linked state
5. If there are more receivers within the MPCW-7 press OPTIONS to go through each
6. Repeat steps 3 thru 5 until all receivers are at their desired state
7. If using profiles save the current profile
8. If using profiles repeat steps 1 thru 7 for all profiles with different wireless settings.
Delete Receiver
The MPCW-7 stores added receivers it uses in memory. If it is necessary to delete a receiver because it is no
longer in use, defective, etc the Delete Receiver menu is used.
Receiver# ◄
SOC FIELD 1 *
Link Receiver
_ ▲
SOC FIELD 1 ▲
Add Receiver
To Next Page
Loading...
Need help?
General
