Newtec EL470 - Page 158

Modem Reference Manual for EL470 IP Satellite Modem
Command
MoGainCtrlState
Gain control state Gain control state
Command ntcDevsMod01MoGainCtrlState
OID 1.3.6.1.4.1.5835.3.1.3.1.13.1.1
Values Factory Default
AGC
Enumeration Value
MGC
Settling
AGC
0
1
2
Command
MoTxStatus
Tx On Tx On
Location /Modem/Monitor/Modulation
Description
Readout of the current transmit status. In case of a modulator, this status
indication is used to drive the Tx On LED.
RMCP
Command
txs Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01ModulatorEntry
Command ntcDevsMod01MoTxStatus
OID 1.3.6.1.4.1.5835.3.1.3.1.37.1.1
Values Factory Default
tx_off
Enumeration Value
OFF
ON
0
1
/Modem/Monitor/Modulation/Packets
Only valid for DVB-S2 modes.
Command
MoInpPacketCnt
Input Packet count Input Packet count
Location /Modem/Monitor/Modulation/Packets
Description
Input packet count. Readout of the total number of packets received by
the modulator board on the interface of the gigabit Ethernet interface
board since the last reset of the counters.
RMCP
Command
ipc Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01ModulatorEntry
Command ntcDevsMod01MoInpPacketCnt
OID 1.3.6.1.4.1.5835.3.1.3.1.71.1.1
Values GUI Unit
NA
Cmd Unit Factory Default (CU)
NA 0
Expert Range (CU)
0 .. 4294967295
version 3.1
151
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS