Newtec EL470 - Page 75

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfDvbs2BboeTxIp
S2BBFoE tx IP
address
S2BBFoE tx IP addres
0.0.0.0 length : 0 .. 15
format : \d{1,3}\.\d{1,3}\.\d{1,3}\.\d{1,3}
Command
IfDvbs2BboeTxUdpPort
S2BBFoE tx UDP port S2BBFoE tx UDP port
Location /Modem/Control/Interfaces/Ethernet/IP termination/S2BBF over IP
Description Configuration of the UDP port number to which DVB-S2 baseband frames
will be transmitted over the Ethernet interface.
RMCP
Command
btU Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfDvbs2BboeTxUdpPort
OID 1.3.6.1.4.1.5835.3.1.4.1.229.1.1
Values GUI Unit
NA
Cmd Unit Factory Default (CU)
NA 12345
Expert Range (CU)
0 .. 65535
/Modem/Control/Interfaces/Ethernet/IP termination/S2BBF over IP/S2BBF oE
instances
Structured Command
IfDvbs2BboeRxInstances
S2BBFoE instances S2BBFoE instances
Location /Modem/Control/Interfaces/Ethernet/IP termination/S2BBF over IP/S2BBF
oE instances
Description
This command allows to configure the configuration data for the DVB-S2
baseband receivers in a single-encapsulator environment.
RMCP
Command
Bri
array : [1 .. 4]
Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfDvbs2BboeRxInstances
OID 1.3.6.1.4.1.5835.3.1.4.1.132.1.1.[1 .. 4]
Variables
IfDvbs2BboeRxEnable
IfDvbs2BboeRxMcastIpAddress
Page
234
234
version 3.1
68
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS