Newtec MDM3100 - 4.7.3 Antenna Controlling

R3.1_v1.2
37/76
Modem Web Interface
User Manual MDM3X00
4.7.3 Antenna Controlling
This submenu is used to enable automatic pointing. Automatic pointing only applies if an Antenna
Control Unit ACU is connected to the modem, as mentioned in AutomaticPointingonpage22.
• Click Edit and select the Automatic Pointing check box to enable this pointing method.
• Click Save .
• Enter values for the parameters which are used for OpenAMIP communication between the
modem and the ACU.