Nidec Control Techniques Digitax-SF DA28C23 - Page 123

36
4. Connections
Digitax SF Instruction Manual
5. Descriptions of CN1 Connector Signals
Pin No.
17
Interface Circuit
PO（Page 46） Control Mode
Signal Description P S T
T-LIMIT
Torque Limiting
Close
Motor output torque is limited.
■ Related Parameters
･No.144.1
Enables you to select conditions for torque limit.
dif.
24
5
i/o
䐟
䐠
䐡
䐢
*
v
ol
t
i/o
䐟
䐠
䐡
v
ol
t
MEND/T-LIMIT
Motion Complete
/Torque Limiting
Close
State of one of the following:
• ....MEND Motion Complete
•
....Torque Limiting
MEND（Pin No.15）
■ Related Parameters
･No.144.1
Enables you to select conditions for torque limiting.
■ TIP
Use this signal as T-LIMIT during press motion. Otherwise, use
it as MEND.
For T-LIMIT, turn TLSEL1 (Torque Limit) ON. For MEND, turn
TLSEL1 (Torque Limit) OFF.
dif.
***
24
***
5
䐟
i/o
䐡
䐢
***
In Standard I/O conguration
In Optional I/O conguration
In I/O conguration Option 1
**
***
*
**
***