Nidec Control Techniques Digitax-SF DA28C23 - Page 275


Digitax SF Instruction Manual
6. Operation
5. Position Control Mode
Homing Based on User-Specied Position（No.645.0=0）
This operation indicates the type of homing based on the starting point.


sensor




Group Name Parameter No.



sensor
645.0
(*)
 646.0


650.0
 653.0


 647.1

 645.1

 657.0

 649.0


651.0

 646.3
 647.0
 646.2
 659.0
Speed
Position
Referenceposition
Origin
Ɂ
Home
Pattern １
Parameters Settings

No.645.0
0

No.645.1
0

No.647.1
0

No.651.0
0

No.657.0
0