Nidec Digistart D3 - Options; Fieldbus Communication Interfaces; Digistart-Soft Software; Digistart D3 - Finger Guard

112 Digistart D3: User Guide
Issue: G
13 Options
Option name
Function
Digistart - DeviceNet
Interface
Fieldbus communications modules
083
17.B
Digistart - Ethernet IP
Interface
Digistart - Modbus Interface
Digistart - Modbus TCP
Interface
Digistart - Profibus Interface
Digistart - Profinet Interface
Digistart - USB Interface
Digistart-Soft
The software allows comprehensive management of soft starters. It provides the
following functionality:
• Operation of soft starter networks containing up to 254 individual soft starters
• Operational control (Start, Stop, Reset, Quick Stop)
• Starter status monitoring (Ready, Starting, Running, Stopping, Tripped)
• Performance monitoring (motor current, motor temperature)
To use Digistart-Soft with the Digistart D3, the soft starter must be fitted with a Modbus
or USB Module.
Digistart D3 - Finger Guard
Finger guards may be specified for personnel safety. Finger guards fit over the soft
starter terminals to pr
event accidental contact with live terminals. Finger guards provide
IP20 protection when correctly installed.
08318.A
Digistart D3 - I/O Expansion
The input/output expansion card provides the following additional inputs and outputs:
• 2 x digital inputs
• 3 x output relays
• 1 x analog input
•
1 x analog output
Digistart D3 - RTD/PT100
and Ground Fault Card
The RTD/PT100 and ground fault protection card provides the following additional
inputs:
• 6 x PT100 RTD inputs
• 1 x ground fault input
To use ground fault protection a 1000:1, 5 VA current transformer is also required.
08447.
A
Digistart D3 - Keypad
Mounting Kit
Allows remote mounting of the keypad up to 3 m away from the soft starter.
Packing list: 1 x cable, 1 x gasket, 4 x screw M3, 4 x flat washer M3, 4 x spring washer
M3, 4 x nut M3, 2 x jack screw, 1 x instructions.