Nidec DUB Series - Set up of Timer

8
Operating procedure Display panel
(1)
Push for more than 5 seconds.
(2)
Input current time. (Example)
(3)
Push
The indicator turns back to show
temperature after displaying time
for 5 seconds.
Operating procedure Display panel
(1)
Push for more than 5 seconds.
2 Installation
2
3. Set up of Timer
[1] How to set time
[2]
Display of time
P.19
For example 13:34
→
→
→
Before noon
7:00
→
Afternoon
7:00
→
Time shows 24 hours a day.
Please be careful.
Installation/Electric work
You can set current time and change it.
Please set current time in advance since it is necessary for set-up of timer.
When you input incorrectly, please push 「0」 for 4
times in a row. Then you can start from the beginning of
operating procedure.
Control panel usually shows the temperature inside of furnace.
When you want to con󳞛rm the current time, you can do as following procedure.
Set up of Timer
* If you do not operate any keys
for 10 seconds, the display
turns back to show the kiln
temperature.
Please operate form the beginning
of operating procedure.
For example 13:34
shows 󳞜ashing.
Installation of the Controller
Install the controller on the right of kiln, and connect with the connector.
① Fix the controller
with two screws.
② Insert it to the connector on the
right bottom side of the kiln.
Switch on the
power (breaker).