Nidec DUB Series - Firing by Self-Produced Programs; About Self-Produced Programs; How to Make Self-Produced Programs

15
Operating procedure Display panel
(1)
Call up a “Basic program” similar with
the program which you want to make.
It is showing the kiln temperature.
(2)
① Push
② Input the temperature which you
want to set into Temperature 1
(3)
① Push
② Input the time which you want to
set into Step 1
(4) Continue setting
5
Firing by controller
2 Firing by “Self-produced” programs
1. About self-produced programs
*If you do not operate any keys for
10 seconds, the display goes back
to show the furnace temperature.
You can change a program into your own speci󳞛cation based on “Basic program” . It is
possible to memorize 20 variations.
2. How to make self-produced programs
Set
Set
*Self-produced programs are not
registered with shipment.
Range possible to input
temperature setting
Maximum 1310℃
Minimum ０℃
Unit: 1℃
→ In the event that you continue the program to 󳞛ring, please go to
“When you start the program you make without registering (preserving)” of the next page.
→
In the event that you register the setting, please go to
“When you start 󳞛ring by the program you register (preserve)” of the next page.
For example
2 Firing by “Self-produced” programs
For example 300min.
For example 600℃
････Time from starting to
････Time from to
････Time from to
････Time from to
････Time for holding at
････Time for holding at
↓
Basic
Prog.
Hold1 Hold2
Temp.1
Temp.4
Temp.3
Temp.2
Step1 Step2 Step3 Step4
P.28
<Note for “Self-produced
programs” >
P.13 / 28
Refer for “Basic-programs”
P.27
<Examples of “Self-produced
programs” by controller>
shows 󳞜ashing.
→ → → →→ →→