Nidec DUB Series - Registration (Preservation) of Continuing Programs; Firing by Continuing Programs

18
Operating procedure Display panel
(1)
Enter into continuing program mode.
More than 5 seconds
(2)
Input the program number which you
register (preserve).
(3)
Push “Start” key.
ー During 󳞛ring ー
(4)
Firing 󳞛nishes when the display shows
“End” .
(5)
Push “Stop” key.
(6) Switch the power (breaker) off.
Operating procedure Display panel
(1)
Push “Start” key after making programs
(continuing of P.17)
― During 󳞛ring ―
(2)
Firing 󳞛nishes when the display shows
“End” .
(3)
Push “Stop” key.
(4) The indicator lights off.
Operating procedure Display panel
(1)
(2)
Number the programs which you register
(preserve). Input any numbers (1 ～ 20).
(3)
(4) Registration 󳞛nishes when buzzer rings.
4. Firing by
“Continuing programs”
The indicator
lights up.
Switch
the power
(breaker) off.
3. Registration (Preservation) of “Continuing programs”
Push after making continuing
programs.
Push again and 󳞛x it.
When you want to start 󳞛ring by continuing programs you make without registering (preserving).
The indicator
lights up.
The indicator
lights off.
When you want to start 󳞛ring by the continuing program which you register (preserve).
3 Firing by “Continuing programs”
5
Firing by controller
Do not touch the kiln for
high temperature.
Be sure to switch the power
off when you open the door.
For example
For example
＋
Self
Prog.
P.10
Please be sure to
read 『Before Firing』
before 󳞛ring.
P.28
Use < Note for “Self-
produced programs” >
DANGER
DANGER
shows 󳞜ashing.
shows 󳞜ashing.
shows 󳞜ashing.
You can register 20 self-
produced programs. Number the
program number from 1 ～ 20.