Nidec DUB Series - Buzzer

20
Operating procedure Display panel
(1)
Enter into the buzzer setting mode.
More than 5 seconds
(2)
Enter into the buzzer setting mode “AL-1”.
(3)
Push the key of the process which you
want to ring the buzzer.
(4)
Input the temperature you want to ring
the buzzer.
(5)
Register (Preserve) the setting.
Operating procedure Display panel
(1)
Enter into buzzer setting mode.
More than 5 seconds
(2)
Set the buzzer “0” and ” AL-0” .
(3)
Register (Preserve) the setting.
1. You do not ring buzzers.
＋
When you want to con󳞛rm the buzzer you set.
Go back to the buzzer setting mode and con󳞛rm the contents of
the display.
＋
More than 5 seconds
6
Convenient functions of controller
2 Buzzer
You can set buzzers in the following 3 ways.
Note:
Once you set the buzzer, the
setting continues in the next
󳞛ring unless you change.
If buzzers are unnecessary, please
set back to “No buzzer(AL-0)” .
1. You do not ring buzzers.
2. You ring the buzzer at the designated temperature in the process you specify.
3. You ring the buzzer after the designated process 󳞛nishes.
2. You ring the buzzer at the designated temperature in the process you specify.
＋
2 Buzzer
Buzzer rings for 20 seconds.
[ AL-2 ]
[ AL-1 ]
[ AL-0 ]
Note:
If you set the buzzer during hold,
it often rings.
Hold1 Hold2
Temp.1
Temp.4
Temp.3
Temp.2
Step1 Step2 Step3 Step4
The indicator
󳞜ashes.
For example
Step2
For example 1275℃
shows 󳞜ashing.
shows 󳞜ashing.
* If you do not operate any keys for 10
seconds, the display turns back to show
the kiln temperature.
* If you do not operate any keys for 10
seconds, the display turns back to show
the kiln temperature.