Nidec DUB Series - Saving Self-Produced Programs into Controller Memory; Firing by Self-Produced Programs

16
Operating procedure Display panel
(1)
(2)
Number the programs which you
register (preserve).
Input any numbers (1 ～ 20).
(3)
(4) Registration 󳞛nishes when buzzer rings.
Operating procedure Display panel
(1)
Push “Start” key after making programs
(continuing of P.15).
― During 󳞛ring ―
(2)
Firing 󳞛nishes when the display shows
“End” .
(3)
Push “Stop” key.
(4) Switch the power (breaker) off.
Operating procedure Display panel
(1)
Push “Self-produced program” .
(2)
Input the program number which you
register (preserve).
(3)
Push “Start” key.
― During 󳞛ring ―
(4)
Firing 󳞛nishes when the display shows
“End” .
(5)
Push “Stop” key.
(6) Switch the power (breaker) off.
5
Firing by controller
2 Firing by “Self-produced programs”
4.Firing by “Self-produced programs”
3. Registration (Preservation) of “Self-produced programs”
Push after making self-produced
programs.
Push again and 󳞛x it.
When you want to start 󳞛ring by self-produced programs you make without registering (preserving).
You can register 20 self-
produced programs. Number the
program number from 1 ～ 20.
When you want to start 󳞛ring by self-produced programs which you register (preserve).
shows 󳞜ashing.
shows 󳞜ashing.
Be sure to switch the power
off when you open the door.
Do not touch the kiln
during 󳞛ring.
For example
For example
Self
Prog.
The indicator
lights up.
The indicator
lights off.
The indicator
lights up.
The indicator
lights off.
P.28
<Note for “Self-produced
programs” >
P.10
Please be sure to read
『Before Firing』 before
󳞛ring.
DANGER
DANGER
shows 󳞜ashing.