Nidec DUB Series - Firing by Continuing Programs; About Continuing Programs; How to Make Continuing Programs

17
Operating procedure Display panel
(1)
Enter into continuing program mode.
More than 5 seconds
More than 5 seconds
(2)
Set the continuing programs.
①
Call up the original self-produced
program.
② Change the contents of the self-produced
program you call up in your preference.
Set
Push
Input the temperature which you want
to set into Temperature 1.
For example 600℃
Set
Push
Input the time which you want to
set into Step 1.
For example 300min.
Continue setting
Push when setting 󳞛nishes
Input again and again since the display
moves to the next LP inputting.
5
Firing by controller
3 Firing by “Continuing programs”
1. About continuing programs
*If you do not operate any keys for
10 seconds, the display goes back to
show the kiln temperature.
You can set the temperature in 16 stages at maximum by combining 4-stages 󳞛rings
based on “Self-produced programs” .
2. How to make continuing programs
*Self-produced programs are not
registered with shipment.
If you push
for more than 5 seconds
again, the display turns back.
Self-produced
programs (4 stages)
Continuing programs (1 ～ 16 stages)
ＬＰ
１
→ In the event that you continue the program to 󳞛ring, please go to
“When you start the program you make without registering (preserving)” of the next page.
→
In the event that you register the setting, please go to
“When you start 󳞛ring by the program you register (preserve)” of the next page.
If you do not want to set
16 stages and stop in the
middle, input 0 ℃ into the
temperature in the next
stage you want to stop.
If you want to change the
program you input, move
to the stage you want to
change and input again.
～
3 Firing by “Continuing programs”
ＬＰ
2
ＬＰ
3
ＬＰ
4
For example
Self-produced
programs (4 stages)
Self-produced
programs (4 stages)
Self-produced
programs (4 stages)
＋
Self
Prog.
→ → → → → →
＋
Self
Prog.
Hold1 Hold2
Temp.1
Temp.4
Temp.3
Temp.2
Step1 Step2 Step3 Step4
Hold1 Hold2
Temp.1
Temp.4
Temp.3
Temp.2
Step1 Step2 Step3 Step4
Hold1 Hold2
Temp.1
Temp.4
Temp.3
Temp.2
Step1 Step2 Step3 Step4
Hold1 Hold2
Temp.1
Temp.4
Temp.3
Temp.2
Step1 Step2 Step3 Step4
shows 󳞜ashing.