11
2 How to remove moisture
Please remove all moisture inside furnace from the moisture venting hole.
If you do ring without ventilation, the kiln will rust.
Take the moisture venting tap off until the temperature becomes from 200 to 300℃ after ring and remove the
moisture inside a work.
↓
Install the moisture venting tap once moisture is removed (when the temperature is from 200 ～ 300℃ .)
DANGER
The moisture inside the kiln will be removed by ring at 200 to 300℃.
Open the door slightly by using the stay, and remove moisture.
After removing the moisture,
close the door and gas drain.
Be careful the inside of the kiln
is very hot.
(1)Preperation of moisture removal
(2) Remove moisture
Open the door
How to x the door slightly opened
Close the door.
Start ring until it reaches 200 to 300℃ .
①
Open the door slowly.
② Get your hands off of the door after making sure that the
door is xed with the stay.
①
Raise the handle and open the door slightly.
② Close the door slowly while pulling the stay.
・ Good ventilation
・ No burnable objects
・ Connection of the earth
wire
Make sure the
following points
in the same way as ring.
(3) Finish the mosture removal
(4) Close the gas drain.
① Push up the door while pulling the stay, then close the
door slowly.
Please be careful about the hot air.
*Wear gloves
Open the cover slightly,
and hung the cutout
portion of the stay.
There is a possibility of
hurting your hand between
the upper door and the kiln
itself.
It is dangerous to heat up
the kiln with the door open.
Close the door before the
temperature becomes over
300℃ . If the error "F1" is
displayed, close the door.
The handle above the door is
very hot, so do not touch the
handle by hand directly. Use
something else such as wood
piece to open it.
Close the door and the gas
drain
△
!
△
!
△
!
How to open the door slightly
Opening and closing of the doorslightly
① Open the door approx. 5cm, and close the door slowly with
pushing the stay.
DANGER
DANGER
To Next Page
Loading...
