36 | Kato Engineering, Inc.
2. Ensure that you are on the same LAN as the connected module and start the Anybus IPconfig
utility and press the “Scan” button. The Anybus modules connected to the network will now
appear in the window as shown in the figure below.
3.
Figure 22 Anybus IPConfig Scan Example
4. In this example we want to modify the settings of the module which “Type” is described as “Anybus-CC
Ethernet/IP”. Double click on the module. The window shown in the below figure should appear.
Figure 23 TCP/IP Configurable Settings
5. Configure the module to the settings required for your application. Pressing the “Set” button stores these
settings in the module itself so that they are retained in non-volatile memory.
To Next Page
Loading...
