Nidec Kato Engineering KRM2000 - Data Tables Index; General Control Register and Part Numbers

49 | Kato Engineering, Inc.
Max value
4294967295
Min value
0
Default value
0
Table 8 General Control Register
Bit
Name
Description
Default
1
Rsvd
N/A
N/A
2
External Filter
Present
40Kohm external filter is present on the rotor.
0
3
Reset to
Defaults
Reset KRM2000™set points to the factory
defaults.
0
4
Rsvd
N/A
N/A
5
Tune loop
voltage
Tune loop antenna for maximum loop voltage.
Set to 0 to tune for minimum loop current.
1
6
Mini Sweep
Tuning Method
Tune loop antenna via “mini-sweep” method. Set
to 0 to use Loop Tuning Step Size to
continuously modify loop frequency.
0
8.3 Data Tables
This section provides an index of what values are available in the different data tables available over
the network interface.
Table 9 Part Numbers Table Index
Part Numbers Table
Hardware Serial Number
Hardware Part Number
Hardware Revision
Software Part Number
DSP Software Revision
Table 10 Unsigned 32 Bit Integer Min/Max Value Table
Op_vars Uint32 Min/Max Data Table
General Control Reg 1 Max
General Control Reg 1 Min
General Control Reg 2 Max
General Control Reg 2 Min
Gnd Flt Trip Count Max
Gnd Flt Trip Count Min
Trip Zone Count Max
Trip Zone Count Min
Trip Zone Retry Count Max
Trip Zone Retry Count Min
Table 11 Floating Point Min/Max Value Table