Nidec NE200 - Page 179

NE200/300 Series Drive User Manual
170 Chapter 6 Parameter description
【50.00Hz】
F9.28 Multi-step freq. 9 Range: 0.00 ～ Max frequency
【50.00Hz】
F9.29 Multi-step freq. 10 Range: 0.00 ～ Max frequency
【50.00Hz】
F9.30 Multi-step freq. 11 Range: 0.00 ～ Max frequency
【50.00Hz】
F9.31 Multi-step freq. 12 Range: 0.00 ～ Max frequency
【50.00Hz】
F9.32 Multi-step freq. 13 Range: 0.00 ～ Max frequency
【50.00Hz】
F9.33 Multi-step freq. 14 Range: 0.00 ～ Max frequency
【50.00Hz】
F9.34 Multi-step freq. 15 Range: 0.00 ～ Max frequency
【50.00Hz】
Define Multi-steps frequency respectively, which can be used in
Multi-step speed running. The terminals defined as multi-steps decide which
step to be run. (See table 6-4)
F9.35 PLC Multi-step frequency 1
selection
Range: 0～4【0】
F9.36 PLC Multi-step frequency 7
selection
Range: 0～4【0】
Define Multi-step 1 & 7 frequency source. When the setting is 0, the first
step and the 7
th
step speed is F9.00 and F9.06
0: Multi-steps running
1: AI1 terminal
2: AI2 terminal
3: keypad potentiometer