Nidec NE200 - 6.9 PID Parameters (F8)

NE200/300 Series Drive User Manual
Chapter 5 List of Parameters 73
Code Description Setting range Default Modify
Modbus
Address
selection
17: Multi-step terminal
1
18: Multi-step terminal
2
19: Multi-step terminal
3
20: Multi-step terminal
4
21: torque control
disable
22: Acc./Dec. time
selector 1
23: Acc./Dec. time
selector 2
24: Running pause
normally open
25: Running pause
normally closed
26: External fault
normally open
27: External fault
normally closed
28: Run command
switch to terminal
29: Run command
switch to keypad
30: External stop
terminal; same to
STOP key in keypad
control mode.
31: Reserved
32: PLC status reset
33: Wobble freq.
pause
34: Wobble freq.
status reset
F6.07
③
X7
terminal
Function
selection
② AI2
terminal
function
selection
0 × 0707H
F6.08
②
Reserve
③ X8
terminal
function
selection
Reserved × 0708H
F6.09
②
Reserve
③ AI1
terminal
function
selection
Reserved ×
0709H