Nidec NE200 - Page 83

NE200/300 Series Drive User Manual
74 Chapter 5 List of Parameters
Code Description Setting range Default Modify
Modbus
Address
35: PID pause
36: PID parameters
switching
37: PID direction
reversion; Active this
terminal to reverse
PID direction set by
F8.04.
38: Timing drive input
39: Counter signal
input
40: Counter clear
41: Actual length clear
42: FWD running
(FWD NC)
43: REV running (REV
NC)
44: HLD (Normally
open)
45: Increase torque
46: Torque increment
clear
47: Decrease torque
48: One key recover
user parameters(Valid
in stop state)
49~56: Reserved
57: Pulse input (Take
X4 in case 2 inputs)
F6.10
Analog
Nonlinear
Selection
0: none
1: AI1
0 × 070AH
2: AI2
3: Pulse
F6.11 AI1 Min. input 0.00 ～ F6.13 0.00V ○ 070BH
F6.12
AI1 Min. input
corresponding
setup
-200.0
～ 200.0% 0.00% ○ 070CH