Nidec NE200 - Page 93

NE200/300 Series Drive User Manual
84 Chapter 5 List of Parameters
Code Description Setting range Default Modify
Modbus
Address
Deviation 1
F8.13
PID parameter
switching
Deviation 2
0.0 ～ 999.9 80 ○ 090DH
F8.14
PID delay time
constant
0.0 ～ 100.0s 0.0s ○ 090EH
F8.15 Deviation limit 0.0 ～ 999.9 0.2 ○ 090FH
F8.16
PID output
positive limit
②
0.0~320.0Hz
③
0.0 ～ 600.0Hz
50.00Hz ○ 0910H
F8.17
PID output
negative limit
0.00 ～ 550.0Hz 0.00Hz ○ 0911H
F8.18 PID preset freq. 0.00 ～ 550.0Hz 0.00Hz × 0912H
F8.19
Hold time of PID
preset frequency
0.0 ～ 3600s 0.0s × 0913H
F8.20
Enable
dormancy
0: Disabled
1: Enabled
0 × 0914H
F8.21 Dormancy delay 0 ～ 999s 120s ○ 0915H
F8.22
Dormancy
threshold
0.0 ～ 320.0Hz 20.0Hz ○ 0916H
F8.23
Awaken
threshold
0.0~100.0%
(relative to pre-set
value)
80.00% ○ 0917H
F8.24
PID feedback
offline detection
range
0.0~100.0%
(relative to feedback
measuring range,
0.0% no detection)
0.0% ○ 0918H
F8.25
PID feedback
offline detection
time
0.0~50.0s 2.0s ○ 0919H
F8.26
PID feedback
offline detection
Min. Freq.
0.00~50.00Hz 10.00Hz ○ 091AH
Group F9: Multi-step speed and PLC