Nidec NE200 - 6.12 Fixed-length control group (Fb); 6.13 Protection and fault parameters group (FC); 6.17 Protection Parameters (FP)

NE200/300 Series Drive User Manual
88 Chapter 5 List of Parameters
Code Description Setting range Default Modify
Modbus
Address
FC.00
Motor overload
protection mode
0: Disabled
1 × 0D00H
1: Common motor
(with low speed
compensation)
2: Variable
frequency motor
(without low speed
compensation)
FC.01
Electro thermal
protection value
20 ～ 110% 100% ○ 0D01H
FC.02
Overload
Pre-alarm
detection level
30.0 ～ 200.0% 160% ○ 0D02H
FC.03
Overload
Pre-alarm
detection time
0.0 ～ 80.0s 60.0s ○ 0D03H
FC.04
Current amplitude
limit
0:Invalid
2 ○
0D04H
1: Acc./Dec. valid;
Constant speed
invalid
2: Valid all the time
FC.05
Current amplitude
limit level
Type G ： 80.0 ～
200.0%
G:
160.0%
○ 0D05H
Type P ： 60.0 ～
150.0%
P:
120.0%
FC.06
Over voltage stall
function
0: Invalid
(Recommended if
braking resistor
mounted)
1 ×
0D06H
1: Valid for Acc/Dec.
2: Valid all the time
FC.07
Overvoltage point
for Acc./Dec.
suspend
110.0 ～ 150.0%
(Bus voltage)
380V:
140%
× 0D07H
220V: