357
❚❚ The Lens Hood
The lens hoods protect the lens and block stray light that would
otherwise cause flare or ghosting.
Attaching the Hood
Align the lens hood mounting mark (●) with the lens hood
alignment mark ( ) and then rotate the hood (w) until the ●
mark is aligned with the lens hood lock mark (—).
When attaching or removing the hood, hold it near the symbol
on its base and avoid gripping it too tightly. Vignetting may
occur if the hood is not correctly attached. The hood can be
reversed and mounted on the lens when not in use.
❚❚ Supplied Accessories
• LC-77 77 mm snap-on Front Lens Cap
• LF-4 Rear Lens Cap
• HB-53 Bayonet Hood
• CL-1218 Flexible Lens Pouch
❚❚ Compatible Accessories
77 mm screw-on filters
To Next Page
