Nikon Labophot - Reassembl y Procedure; Coaxial Coarse and Fine Focus Unit

REASSEMBL Y PROCEDURE
e~~~
'123f109 f 105 i 106)
. '--.__/ "-._/' \.___./
1 •
; I \
Fig. 37
R-4104.A
1. Coaxial Coarse and Fine Focus Knob Unit
7) Attach gears e@ and @ to pinion case @ , and coarse focus knob bearing @
(this should be cleaned, beforehand) to e@ by means of screws @x3. e@ and
e@ are to be oiled as shown in Fig. 36, after cleaned and dried.)
8) lnsert the subassembly consisting of
e@]) (coarse focus case) and @ (coarse focus
shaft) and @ and @ (gears), as shown in Fig. 37 (apply oil to @ as shown in
Fig. 10).
9) Thereafter, following 4)- l ), reverse the disassembly procedure. (After cleaned and dried,
fine focus shaft @ , gears @ and @, @, e@ and @ and gears @
and @ should be oiled as shown in Fig. 24.
Cover plate @ is to be cemented by No. 616. Apply G7920 to plate spring e@ and
washer @.
- 33 -