Why is there no [SLEEP] button on the [MICROSCOPE CONTROL] screen of my Nikon Ni-E Control Unit?
If there is no [SLEEP] button on the [MICROSCOPE CONTROL] screen, the [SLEEP] button might be set to be hidden on the [BUTTON FUNC] screen. Configure to show the [SLEEP] button on the [BUTTON FUNC] screen.
Why won't my Nikon Control Unit buttons work on the microscope?
If the buttons on the microscope are not working, it could be because the buttons are disabled. You should enable the button operation.
What to do if buttons to operate motorized devices do not appear on my Nikon Control Unit?
If the buttons to operate the motorized devices or the configuration screen for motorized devices do not appear (excluding the digital camera and motorized shutter connected to the DSC connector), it could be due to a couple of reasons. For Ni-E and Ni-U, the system configuration might be set not to display the buttons, so change the layout of buttons. Also, the devices might not be connected properly. Turn off the microscope, motorized accessory devices, and DS-L4, then correctly connect or attach motorized devices to the microscope.
What to do if capturing with a digital camera cannot be started on Nikon Control Unit?
If capturing with a digital camera cannot be started, the camera trigger cable might not be properly connected. Turn off the microscope, DS-L4, and the camera, then reconnect the camera trigger cable of the digital camera to the microscope. Also, the connection of the digital camera might not be configured correctly. Check the connection between the digital camera and the DSC connector, and configure the system accordingly.
What to do if Nikon Ni-E operation is not performed as intended when the buttons are pressed?
If the operation is not performed as intended when the buttons on Ni-E main body or ergo controller are pressed, the functions might not be correctly configured.
What to do if the FL SHUTTER or CW/CCW button does not activate the intended device on Nikon Ni-E?
If the FL SHUTTER button or CW/CCW button is pressed on the microscope, and the intended device is not activated, the target for each operation by button might not be correctly configured. Change the targets of button operations.
What to do if the motorized nosepiece skips addresses on Nikon Control Unit?
If the motorized nosepiece skips addresses, the toggle function might be ON. Turn the toggle function OFF.
Why is the state of the [INTELLIGENT] restored to the previous value when DS-L4 is turned on?
If the state of the [INTELLIGENT] is restored to the previous value when DS-L4 is turned on, the state of the [INTELLIGENT] might not be saved. Save the state of the [INTELLIGENT] as an initial value.
What to do if motorized devices are not interlocked when rotating the nosepiece on Nikon Control Unit?
If motorized devices are not interlocked when rotating the nosepiece, adjusting the zoom magnification, switching the optical path, or with the output of capture command/capture trigger signal, interlocking might not be configured. Configure interlocking.
What to do if settings are restored to the previous value when DS-L4 is turned on?
If settings are restored to the previous value when DS-L4 is turned on, the settings might not be saved. After configuring the settings, be sure to press the [SAVE] button on the [MIC SETUP] - [MAIN] screen to save settings.
General| Brand | Nikon |
|---|---|
| Model | DS-L4 |
| Category | Microscope |
| Language | English |
To Next Page
