Nikon DS-L4 - Drawing Straight Lines and Arrows

Chapter 11 Adding Lines and Annotations to an Image
120
Scale, Annotation,
and Measurement
Functions
11.5.2
Drawing Straight Lines and Arrows
By specifying two points on the screen, you can draw a straight line or arrow between the two points.
1 Display [TOOL MENU: MEAS/DRAW].
2 Tap [LINE] or [ARROW].
3 On the screen, draw a straight line or arrow by dragging
the mouse pointer from the starting point to the end
point.
To use a drag or swipe operation to move an image enlarged
by electronic zoom, tap [DRAW MODE], and then select
[MOVE MODE].
If an image has been enlarged by electronic zoom, you
cannot draw a line beyond the image display area.
To draw another straight line or arrow, repeat the above
steps.
4 Tap [CLOSE] to close the [LINE] or [ARROW] menu.
Drawing a straight line
To edit an existing straight line or arrow
You can change the length or rotation angle of an existing straight line or arrow. To do this:
(1) Tap [SELECT].
(2) Tap and select the straight line or arrow that you want to edit.
(3) Edit the straight line or arrow.
- You can move the straight line or arrow by mouse dragging.
- By mouse-dragging an end point of the straight line or arrow, you can change its length or rotation angle.
(4) To redisplay the [LINE] or [ARROW] menu, tap [X] on the [SELECT] menu.
[DRAW MODE]
1 2
3
4