Chapter 11 Adding Lines and Annotations to an Image
119
Scale, Annotation,
and Measurement
Functions
11.5.1
Adding a Text Annotation
You can add a text annotation at any position on the screen.
1 Display [TOOL MENU: MEAS/DRAW].
2 Tap [TEXT].
3 On the screen, specify the position at which you want to
add a text annotation.
4 Enter text (a maximum of 32 characters), and then tap
[OK].
To add another text annotation, repeat steps 3 and 4.
5 Tap [CLOSE] to close the [TEXT] menu.
Adding a text annotation
To move or rotate an existing text annotation
To move or rotate an existing text annotation, use the [TEXT] menu to perform the following procedure:
(1) Tap [SELECT].
(2) Tap and select the text annotation you want to edit.
(3) Move or rotate the text annotation. (You cannot change the text itself.)
- You can move the text annotation by mouse dragging.
- You can rotate the text annotation by mouse-dragging an end point of the text annotation.
(4) To display the [TEXT] menu again, tap [X] on the [SELECT] menu.
1
2
3
5
Erases all text
annotations.
Tap to specify
the position.
To Next Page
Loading...
