What to do if settings are restored to the previous value when DS-L4 is turned on?
If settings are restored to the previous value when DS-L4 is turned on, the settings might not be saved. After configuring the settings, be sure to press the [SAVE] button on the [MIC SETUP] - [MAIN] screen to save settings.
What to do if interlocked operation when switching objectives does not work as intended on Nikon Control Unit?
If interlocked operation when switching objectives does not work as intended, the interlocking might not be correctly configured, so configure correctly. Another cause might be an incorrect configuration of the objectives, so configure correctly.
What to do if the [ESCAPE] button is disabled on Nikon Control Unit?
If the [ESCAPE] button is disabled, the stage may have been moved to the specimen removal position. Press the [Specimen Removal Position] button to reset the specimen removal position.
What to do if my Nikon Control Unit buzzer doesn't sound when I press buttons?
If the buzzer does not sound when buttons are pressed, it is possible that the buzzer is turned off. Turn on the buzzer.
Why is the intended digital camera not working when I press the CAPTURE button on my Nikon microscope?
If the intended digital camera does not work when the CAPTURE button is pressed on the microscope, the target of the button operation might not be correctly configured. Change the target of the button operation.
How to fix incorrect optical elements information on Nikon Control Unit?
If the information about optical elements is not displayed correctly, or an incorrect element enters the optical path when a button is pressed, the information might not be configured correctly. Set the correct information in [MIC SETUP] ? [COMPONENTS].
What to do if capturing with a digital camera cannot be started on Nikon Control Unit?
If capturing with a digital camera cannot be started, the camera trigger cable might not be properly connected. Turn off the microscope, DS-L4, and the camera, then reconnect the camera trigger cable of the digital camera to the microscope. Also, the connection of the digital camera might not be configured correctly. Check the connection between the digital camera and the DSC connector, and configure the system accordingly.
What to do if buttons to operate motorized devices do not appear on my Nikon Control Unit?
If the buttons to operate the motorized devices or the configuration screen for motorized devices do not appear (excluding the digital camera and motorized shutter connected to the DSC connector), it could be due to a couple of reasons. For Ni-E and Ni-U, the system configuration might be set not to display the buttons, so change the layout of buttons. Also, the devices might not be connected properly. Turn off the microscope, motorized accessory devices, and DS-L4, then correctly connect or attach motorized devices to the microscope.
Why won't my Nikon Control Unit buttons work on the microscope?
If the buttons on the microscope are not working, it could be because the buttons are disabled. You should enable the button operation.
General| Brand | Nikon |
|---|---|
| Model | DS-L4 |
| Category | Microscope |
| Language | English |
To Next Page
